support wrote:1) Do you use "above 4G" option for your graphic adapter? For eg, on your BIOS setting, there may be an item called "IGP Memory Addressing" or similar item, the value can be "above 4G" or "below 4G". If use "above 4G", it will conflict with the ramdisk with Invisable Memory enabled.
2) Could you try to crate a ramdisk with 100MB IM used to test if the image file can be loaded normally?
An attempt was made to access a pageable (or completely invalid) address at an
interrupt request level (IRQL) that is too high. This is usually
caused by drivers using improper addresses.
If kernel debugger is available get stack backtrace.
Arg1: 6e0b8e44, memory referenced
Arg2: 000000ff, IRQL
Arg3: 00000001, value 0 = read operation, 1 = write operation
Arg4: 8a48641c, address which referenced memory
8a48641c ?? ???
TRAP_FRAME: 805513b4 -- (.trap 0xffffffff805513b4)
ErrCode = 00000002
eax=6e0b8e44 ebx=ffdffc70 ecx=ffdffc70 edx=00000f77 esi=ffdffc50 edi=8a517170
eip=8a48641c esp=80551428 ebp=80551450 iopl=0 nv up di pl nz na pe nc
cs=0008 ss=0010 ds=0023 es=0023 fs=0030 gs=0000 efl=00010006
8a48641c ?? ???
Resetting default scope
LAST_CONTROL_TRANSFER: from 8a48641c to 805446f0
805513b4 8a48641c badb0d00 00000f77 b811a162 nt!KiTrap0E+0x238
WARNING: Frame IP not in any known module. Following frames may be wrong.
80551424 b811a162 00000008 00000206 ffdffc70 0x8a48641c
80551434 80528799 ffdff000 8055c0c0 8055be60 intelppm!AcpiC1Idle+0x12
80551450 80545d4c 00000000 0000000e 00000000 nt!PopProcessorIdle+0xa9
80551454 00000000 0000000e 00000000 00000000 nt!KiIdleLoop+0x10
b811a162 6a00 push 0
3) Is it the first version (1.8.3601.2338) you used? Did you use the previous version before, for eg. V1.6.3518.2339? Just want to know if this problem occurrs only in v1.8.3601.2338.
support wrote:hmmm, could you provide the hardware information, especially about CPU and motherboard? Are you using AMD cpu?
And could you send the this crash dump file to us? email@example.com
From the crump file, problem is related to intelppm.sys. If you would like to help us do a test at first, you may disable this driver: at registry HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\Intelppm
change the 'Start' value to '4'.
After reboot, create the ramdisk using 100MB IM again to see what would happen.
Users browsing this forum: No registered users and 2 guests